Vol. 1 No. 2 (2022)

Articles

• FEM ANALISYS OF DEEP DRAWING PROCESS

  Saša Ranđelović, Mladomir Milutinović, Marina Trajković, Dejan Movrin, Nikola Kostić

  1 - 10

  • PDF

• DEVELOPMENT AND ANALYSIS OF SURFACE ROUGHNESS MODEL IN DRY LONGITUDINAL TURNING OF C45E STEEL

  Milos Madic, Milan Trifunović, Tamara Janković

  11 - 21

  • PDF

• INVESTIGATION OF THE CUTTING PARAMETERS INFLUENCES ON SURFACE ROUGHNESS IN TURNING AISI 1045 STEEL

  Rajko Turudija, Predrag Jankovic, Milos Stojkovic, Milos Madic, Milica Ivanovic

  22 - 33

  • PDF

• PARTIAL EFFECT OF CUTTING PARAMETERS ON ENGAGED POWER AND ENERGY CONSUMPTION: THE CASE OF EXTERNAL TURNING OF AN AISI1045 STEEL

  Milos Stojkovic, Milan Trifunovic, Milos Madic, Rajko Turudija, Miodrag Manic

  34 - 47

  • PDF

• SELECTION OF NON-CONVENTIONAL MACHINING PROCESSES USING MCDM SOLVER

  Dušan Petković, Miloš Madić

  48 - 57

  • PDF

• A REVIEW OF 3D PRINTED CARBON FIBER REINFORCED PLA COMPOSITES IN FUSED FILAMENT FABRICATION

  Jelena Stojković, Rajko Turudija

  58 - 79

  • PDF

• CAD SYSTEM EVALUATION BASED ON USER INTERFACE EFFICIENCY

  Dragan Misic, Miroslav Trajanovic, Nikola Korunovic, Jovan Arandjelovic, Pavle Draskovic, Rajko Turudija

  80 - 95

  • PDF

• REMODELING OF COMPLEX SURFACE PATCHES BY USING THE METHOD OF CHARACTERISTIC FEATURES – THE SKI SHOE HEEL LIP EXAMPLE

  Nikola Vitković, Nikola Korunović, Jovan Aranđelović, Aleksandar Miltenović, Marko Perić

  96 - 105

  • PDF

• MECHANICAL ENGINEERING DESIGN OPTIMIZATION USING THE HONEY BADGER ALGORITHM

  Đorđe Jovanović, Branislav Milenković, Mladen Krstić

  106 - 115

  • PDF

• POTENTIALS OF CLAY AS A PHASE CHANGE MATERIAL

  Gradimir Cvetanović, Staniša Stojković, Predrag Rašković, Predrag Živković

  116 - 129

  • PDF

• MODES OF NON-HOMOGENEOUS DAMPED BEAMS ON A WINKLER-TYPE ELASTIC LAYER

  Nikola Nešić, Goran Janevski, Predrag Kozić

  130 - 152

  • PDF

• MODELING AND SIMULATION OF STOCHASTIC PROCESSES

  Ivan Pavlović, Dunja Milić

  153 - 162

  • PDF